本生產線是采用平膜頭擠出機將PE（聚乙烯）顆粒材料附(丙綸或滌綸布)一次擠出而成，可取代二次加熱的復合機。此設備生產的產品不起鼓、不翹邊，粘結密實，性能穩定、質量可靠,完全達到或超過GB18173.1－2006標準。同時該設備還具有自動化程度高、耗電低、用工少、產出的卷材成本低等綜合優勢。
Have been melted into molten state, the PE（polyethylene）granules are extruded into membrane with the flat and straight extrusion die of the equipment, followed by polypropylene fiber or dacron affixed on the core membrane. With the characteristics of stable performance and excellent durability, the product conforms to the national standards of GB18173.1-2006.High automatcity, low power consumption, low cost, high yield, less manual labor.
技術參數 Technical Parameter
主機均采用先進變速技術，節電達30%
Host adopt advanced trans-mission technology, saving
electricity up to 30%.
自動加熱系統均采取厚模電路，節電達40%左右。
Automatic heating system had taken thick-circuit,saving electricity about 40%.
擠出機SJ90 減速機SJY400 主機功率:30KW
Extruder SJ90 Reducer SJY400 Engine Power: 30 KW
擠出料筒 采用38CYMOALA材料，進行氮化處理 螺桿加熱功率:19KW
Extruder barrel can be used 38CYMOALA materials with nitriding treatment. Screw heating power is 19 KW
模具 外式加熱 功率:23KW
Die can be with outer heating system,power is 23KW.
三輥機臥式 輥筒表面為硬鉻處理 功率
Three-Roller Device is horizontal style, surface of roller was with hard chrome treatment.Power is 1.1KW.
牽引機采用耐磨橡膠輥，力矩牽引 功率：10N
Traction Device can be used wear-resistant rubber roller with torque traction. Power is 10N.
計米器J250-001型 傳動比：1:1
Meters Model J250-001 Ratio is 1:1
卷取機 四輥摩擦收卷 功率：
Winding Unit is with four-roller friction winders.Power is 0.75KW.
|
|
